SUBFRAME With Steering Gear, Removing And Installing: Installing

Install in reverse order of removal and Note The Following:

-- Remove the :T40327 . Refer to SUBFRAME, SECURING .

-- Install the steering intermediate shaft. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .

NOTE:

Bonded rubber bushings have a limited range of rotation. Only tighten the threaded connections for the suspension when the vehicle is in curb weight position.

-- Lift the wheel bearing in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

WARNING:

Risk of accident!

If the vehicle will be driving on the streets, all bolts and nuts must be tightened properly according to the guidelines.

-- Connections and wire routing. Refer to the appropriate Wiring Diagram(s).

Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .

NOTE:

If the steering wheel is crooked with the steering gear after an earlier removal of the subframe, then an axle alignment is necessary.

Adjust the headlamps. Refer to HEADLAMP, ADJUSTING .
Driver assistance systems front camera, calibrating. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .