Overview - Shift Mechanism

Selector Mechanism in the Vehicle Interior

Fig 1: Exploded View Of Shift Mechanism

Courtesy of AUDI OF AMERICA, LLC

1. Shift Mechanism
   • With the following integrated components:
     • Selector Lever -E313-
     • Selector Lever Position Sensor -G727-
     • Transverse Selector Lever Lock Sensor -G868-
     • Selector Lever Sensor System Control Module -J587-
     • Shift Lock Solenoid -N110-
     • Transverse Selector Lever Lock Motor -V577-
   • The components cannot be replaced separately if faulty.
   • Removing and Installing. Refer to SHIFT MECHANISM, REMOVING AND INSTALLING .
2. Selector Lever Transmission Range Display -Y5-
   • Removing and installing. Refer to COMPONENT LOCATION OVERVIEW - CENTER CONSOLE LAMPS .
3. Selector Lever Handle, Upper Section
   • Removing and Installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
4. Bolt
   • 3.2 Nm
   • Not available separately
5. Selector Lever Handle, Lower Section
   • With the following integrated components:
     • Selector Lever Release Button -E681-
     • Parking Lock Button -E816-
   • The components cannot be replaced separately if faulty.
   • Removing and Installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
6. Selector Lever Boot
   • Removing and Installing. Refer to SELECTOR LEVER BOOT ON SELECTOR LEVER HANDLE, DISCONNECTING AND ASSEMBLING .
7. Bolt
   • 8 Nm

Gearshift Mechanism on Transmission 

Fig 2: Exploded View Of Gearshift Mechanism On Transmission

Courtesy of AUDI OF AMERICA, LLC

1. Drive Position Sensor -G676-
   • Removing and Installing. Refer to Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING .
2. Shaft
   • For the parking lock
3. Bolt
   • 3 Nm +90°
   • Replace after removing
   • M6 X 30
4. Parking Lock Solenoid -N486-
   • Electro-hydraulic part
   • Removing and Installing. Refer to Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING .
5. Seal
   • Replace after removing
6. Seal
   • For the parking lock shaft
   • Replacing. Refer to PARKING LOCK SHAFT SEAL, REPLACING .
7. Spring Pin
8. Lever
   • For the parking lock
   • Removing and Installing. Refer to PARKING LOCK SHAFT SEAL, REPLACING .
9. Cover
   • For the parking lock
   • With electric wiring harness
10. Bolt
    • 3 Nm +45°
    • Replace after removing
    • M6 X 14
11. Bolt
    • 8 Nm +60°
    • Replace after removing
    • M8 X 22
12. Alignment Pin
    • Quantity: 2
13. Bolt
    • 3 Nm +180°
    • Replace after removing
    • M6 X 55
14. Bolt
    • 3 Nm +90°
    • Replace after removing
    • M6 X 35