Engine, Removing From Scissor Lift Table

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Engine Sling: 2024A

Fig 1: Engine Sling : 2024A
Courtesy of AUDI OF AMERICA, LLC
Shop Crane: VAS6100

Fig 2: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC

Procedure

Engine/transmission assembly removed and separated on Scissor Lift Table: VAS6131B . Refer to ENGINE AND TRANSMISSION, SEPARATING .

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of injury from the lifted engine/motor falling.

The possibility for parts of the body to be pinched or crushed increases.

- Secure the mounting hooks and pins on the lifting tackle with a securing pin.

-- Engage the Engine Sling: 2024A -1- as shown on the engine lifting eye and on the Workshop Crane: VAS6100 -2-.

-- Insert the securing pins -arrows- to secure the mounting hooks and alignment pins.

CAUTION:

Risk of injury due to the engine weight shifting.

The possibility for parts of the body to be pinched or crushed increases.

- Transport the engine only without the transmission using the method described.

-- Tension the engine slightly with the shop crane, but do not lift.

-- Remove the Articulated Joint Support: VAS6131/13-7 from the engine.

Courtesy of AUDI OF AMERICA, LLC

-- Lift the engine using the workshop crane.