Drive Motor Rotor Position Sensor 1 -G713-, REMOVING AND INSTALLING:: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
- Press in the flat terminal using the Release Tool Set - Extraction Tool 10A: VAS1978/10A .
-- If the Drive Motor Rotor Position Sensor 1 -G713- is replaced, then the Drive Motor Rotor Position Sensor 1 -G713- must be adapted.
-- Connect the Vehicle Diagnostic Tester.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Electrical system
- 01 - OBD-capable systems
- 51 - Electrical Drive Control Module - J841
- 51 - Electric Drive, Functions
- 51 - Basic Setting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.