Overview - MECHATRONIC
TFSI e (0DK) different illustration. Refer to OVERVIEW - MECHATRONIC .
- Transmission Fluid Pan
- Removing and Installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Tightening specification and sequence. Refer to Fig 2.
- Bolt
- M6 X 30
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 4.
- Bracket
- Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-
- Removing and Installing. Refer to Hydraulic Pressure Sensor 1 -G545- AND Hydraulic Pressure Sensor 2 -G546-, REMOVING AND INSTALLING .
- Seals
- Replace after removing
- Contact Element
- Bolt
- M6 X 25
- Replace after removing
- 3 Nm +90°
- O-Ring
- Replace after removing
- Bleed Pipe
- Dust Ring
- Seals
- Replace after removing
- Seal
- For vehicles with Parking Lock Solenoid -N486-
- Replace after removing
- Mechatronic
- Removing and Installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Mechatronic Bolts
- M6 X 90
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- M6 X 22
- For vehicles with Parking Lock Solenoid -N486-
- Replace after removing
- 3 Nm +90°
- Seal
- Replace after removing
- Figure
- Transmission Control Module -J217-
- Oil Pipe
- For vehicles with Parking Lock Solenoid -N486-
- Wiring Guide
- Replace after removing
- Seals
- Replace after removing
- ATF Pipe
- Replace after removing
- Seals
- Replace after removing
Transmission fluid pan - tightening specification and sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 25- | Install all the way by hand |
| 2 | -1 to 25- | 3 Nm for the aluminum bolt, 8 Nm for the steel bolt |
| 3 | -1 to 25- | 90° additional turn |
Mechatronic - Tightening Specification and Sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 7- | Install all the way by hand |
| 2 | -1 to 7- | 8 Nm |
| 3 | -1 to 7- | 120° additional turn |
Hydraulic Pressure Sensor 1 G545 and Hydraulic Pressure Sensor 2 G546 - tightening specification and sequence
Courtesy of AUDI OF AMERICA, LLC| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 7- | Install all the way by hand |
| 2 | -1 to 7- | 8 Nm |
| 3 | -1 to 7- | 120° additional turn |