Transmission Fluid Auxiliary Hydraulic Pump -V552-, REMOVING AND INSTALLING: Removing
Contamination damages the Mechatronic.
- A clean work environment is required for working on the Mechatronic.
The system is under pressure.
- Deactivate the ATF pump and drain the hydraulic pressure reservoir before removal.
-- Using the Vehicle Diagnostic Tester, empty the ATF pressure reservoir in the Transmission Control Module -J217- and disable the Transmission Fluid Auxiliary Hydraulic Pump -V552-. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
-- Remove the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
-- Remove the Transmission Control Module -J217-. Refer to Transmission Control Module -J217-, REMOVING AND INSTALLING .
-- Secure the Mechatronic on the vise as shown using the Support: T40321 .
-- Remove the bolts -arrows-.
-- Remove the ATF motor -1- and the ATF pump -2- downward, at the same time pay attention that the ATF pump -2- does not fall down.
