Input Shaft 1, Removing And Installing Individually: Installing

Courtesy of AUDI OF AMERICA, LLC

-- Carefully guide the input shaft 1 into the gear set -arrow-. While doing so, make sure the needle bearings -A and B- are installed correctly.

-- Position the shift forks and secure with the bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

AWD Vehicles

Courtesy of AUDI OF AMERICA, LLC

-- Warm the bearing inner race using the Inductive Heater :VAS 6414  to approximately 100 °C (212 °F) and push in all the way downward with the shoulder -arrow A-.

-- Install the circlip -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the gear set. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .