Valve Stem Seals, Removing And Installing, Cylinder Head Removed: Installing

Fig 1: Insert The Valve Stem Seal In The 3365

Courtesy of AUDI OF AMERICA, LLC

• In order not to damage the valve stem seal -4- during installation, mount the Assembly Tool: T40452  -3- on the valve stem -2-.

-- Lightly oil the valve stem seal sealing lip.

• Depending on the version of the valve stem seal, use the Seal Installer - Valve Stem: 3365  or Fitting Tool: T40376/1 

-- Insert the valve stem seal into the seal installer -5- and carefully press it all the way onto the valve guide -1- over the Mounting Sleeve.

-- Remove the Assembly Tool.

If the valve retainers were removed from the assembly cartridge, they must be inserted into the Valve Cotter Tool Kit - Valve Insertion Device: VAS5161/18  first.

Fig 2: Identifying Installation Cartridge VAS 5161/8

Courtesy of AUDI OF AMERICA, LLC

• The large diameter of the valve retainers point upward.

-- Press the assembly cartridge from above onto valve retainer inserting tool and valve retainers.

-- Insert the valve spring and the valve spring retainer. Refer to Figure.

-- Attach the Valve Cotter Tool Kit - Guide Plate: VAS5161/19C  onto the cylinder head again.

Fig 3: Identifying Valve Cotter Tool Kit - Guide Plate 19c VAS5161/19C

Courtesy of AUDI OF AMERICA, LLC

-- Insert the assembly cartridge into the guide plate.

-- Press the pressure fork down and pull the knurled bolt up while turning left and right. This inserts the valve retainers.

-- Release the pressure fork with the knurled bolt still raised.

-- Repeat the procedure on each valve.

Assembling 

-- Install the intake manifold. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .