Overview - Impact Member

Fig 1: Exploded View Of Impact Member

Courtesy of AUDI OF AMERICA, LLC

1. Molded Foam Part
   • Depending on the version
   • Removing and Installing. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
2. Bracket
   • For the Outside Air Temperature Sensor -G17-
3. Bolt
   • 2.5 Nm
   • Depending on the version
4. Outside Air Temperature Sensor -G17-
   • Removing and Installing. Refer to ADDITIONAL COMPONENTS FOR CONTROL AND REGULATION .
5. Impact Member
   • Removing and Installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
6. Bolt
   • 55 Nm
   • Quantity: 4
7. Lock Carrier
8. Bolt
   • Tightening specification Fig 2
   • Quantity: 2
9. Bolt
   • 14 Nm
   • For securing the impact member to the lock carrier
   • Quantity: 2
10. Nut
    • Tightening specification. Refer to OVERVIEW - HORN .
11. Bracket with Horn
    • Removing and Installing. Refer to HIGH TONE HORN -H2- /LOW TONE HORN -H7-, REMOVING AND INSTALLING .
12. Impact Member Mount
    • Removing and Installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
13. Connecting Brace
    • Market-Specific Version
14. Bolt
    • 9 Nm
    • Quantity: 2
15. Nut
    • Quantity: 2
16. Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
    • Unit with pressure hose
    • Must be replaced when
      • Molded foam part visibly damaged
      • The impact member is visibly deformed.
      • The bumper cover is deformed.
      • The pressure hose is damaged.
    • Removing and Installing. Refer to OVERVIEW - PEDESTRIAN PROTECTION .

Front Impact Member - Tightening Specification and Sequence 

Fig 2: Front Impact Member

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -A- to 23 Nm in the following sequence: -1 through 4-.