Reflector, Removing And Installing: Installing

• The vehicle and the reflector must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Clean the plastic side of the adhesive surface with Cleaning Solution :D 009 401 04  and let dry.

-- Apply Plastic Primer : D 366 PR1 A1  on the plastic side of the adhesive surface and let dry until the solvent has completely evaporated.

• Apply the reflector within 60 minutes.

-- Remove the protective films from the adhesive tape -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Position the reflector -2- and press it onto the bumper cover -3-.

• Resting time approximately 30 minutes at room temperature