Overview - Fuel Delivery Unit/Fuel Level Sensor, TFSI Vehicles Rest Of World Market-Specific Version
Courtesy of AUDI OF AMERICA, LLC- Fuel Level Sensor
- Fuel Gauge Sensor -G-, Removing and installing. Refer to Fuel Gauge Sensor -G-, REMOVING AND INSTALLING .NOTE:
The Fuel Level Sensor 2 -G169- is integrated in the fuel tank and cannot be replaced separately.
- Fuel Gauge Sensor -G-, Removing and installing. Refer to Fuel Gauge Sensor -G-, REMOVING AND INSTALLING .
- Fuel Line
- To the engine
- Do not kink
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Connector
- For Fuel Pump Control Module -J538-
- Make sure it is attached securely
- Fuel Pump Control Module -J538-
- Checking using the Vehicle Diagnostic Tester.
- Component location: right under the rear sill panel
- Removing and installing. Refer to Fuel Pump Control Module -J538-, REMOVING AND INSTALLING .
- Sealing Flange Cover
- Bolt
- 1.5 Nm
- Quantity: 3
- Fuel Line to Parking Heater Metering Pump
- Equipped on some models
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Connector
- To the metering pump for the parking heater
- Make sure it is attached securely
- Locking Ring
- 110 Nm
- Loosen and tighten using the Wrench - Fuel Sending Unit :T10202
- Gasket
- Replace after removing
- Install dry
- Wiring Harness
- for Transfer Fuel Pump -G6-, Fuel Gauge Sensor -G- and Fuel Gauge Sensor 2 -G169-
- Make sure it is attached securely
- Fuel Delivery Unit
- With the Transfer Fuel Pump -G6-
- With integrated fuel filter, the fuel filter cannot be replaced individually
- Fuel pump checking electronically using Vehicle Diagnostic Tester.
- Removing and installing. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING, TFSI VEHICLES .
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS .
- Fill the vehicle with at least 5 liters (5.28 quarts) of fuel after installing