Led Headlamp, Adjusting, North AMERICA Market Versions, Before Product Improvement: Notes

The Headlamp Must Be Calibrated after the Following Procedures:

• Headlamp position was changed (removing and installing, loosening and tightening the screws)
• The Drivetrain Control Module -J775- was calibrated or replaced.
• The Vehicle Electrical System Control Module -J519- was replaced.
• The Left Rear Level Control System Sensor -G76-, Right Rear Level Control System Sensor -G77-, Left Front Level Control System Sensor -G78- or Right Front Level Control System Sensor -G289- was replaced.
• There is an entry in the DTC memory that indicates the headlamp basic setting is missing.

Requirements 

• Pay attention to the testing and adjustment requirements. Refer to HEADLAMP, ADJUSTING, GENERAL INFORMATION .
• The angle dimension is set on the headlamp adjusting unit. Refer to the the appropriate Headlamp Adjusting Unit Operating Instructions.