RIGHT AND LEFT LED HEADLAMP POWER OUTPUT Module 1 -A27- / -A31-, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT: Removing
-- Vehicles with parking heater on right side of the vehicle: Remove the front bumper cover. Refer to FRONT BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the front wheel spoiler. Refer to WHEEL HOUSING LINER .
-- Remove the air intake grille. Refer to FRONT BUMPER .
-- Remove the headlamp washer system washer nozzle and move it to the side with the washer fluid hose still attached. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
-- Remove the horn bracket and move it to the side with the wire still attached. Refer to HIGH TONE HORN -H2- /LOW TONE HORN -H7-, REMOVING AND INSTALLING .
-- Remove the bolts -arrows-.
-- Remove the power output Module -1-.
-- Disconnect the connector -2-.
-- To disconnect push the connector tab -3-, pivot the retaining bracket -4- upward and remove the connector.
-- Remove the front bumper cover. Refer to FRONT BUMPER COVER, REMOVING AND INSTALLING .
-- Left: release the catches -arrow- and remove the air duct -3-.
-- Remove the headlamp washer system washer nozzle and move it to the side with the washer fluid hose still attached. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
-- Remove the screws -arrows-.
-- Remove the power output Module -1-.
-- Disconnect the connector -5-.
-- To disconnect push the connector tab -4-, pivot the retaining bracket -3- upward and remove the connector.