Power Rear Lid Opening Control Module -J938-, REMOVING AND INSTALLING, VERSION 1: Removing

-- Remove the nuts/bolt -arrows- on the lower section of the bumper cover.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1 and 2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the control module -1- from the brackets on the bumper cover -2- in direction of -arrows-.

-- If the control module is replaced, release the tab -3- in direction of -arrow- and disengage the bracket -2- from the control module -1-.

Fig 1: Opening Retainer -3- -Arrow- And Disengage Bracket -2- From Control Module -1-

Courtesy of AUDI OF AMERICA, LLC