Wheel Covers, Removing And Installing, Front: Installing

Install in reverse order of removal and note the following:

• The vehicle and the cover must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04  and let dry.

-- Apply Bonding Agent: D 355 205 A2  -1- on the painted side of the adhesive surface -2- using the Applicator: D 009 500 25  -3- and let it dry for ten minutes.

Fig 1: Applying Bonding Agent To Adhesive Surface On Paint Side Using Applicator

Courtesy of AUDI OF AMERICA, LLC

• If the Bonding Agent: D 355 205 A2  dries longer than two hours, then it must be primed again.

-- Fold back the end of the protective film, or attach a pulling aid to the protective film.

-- Use the centering pins -4- to insert the wheel cover -1- into the cut-outs -3- on the fender -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the protective film on the pulling aids from the adhesive tape -5-.

-- Push on the wheel cover -1- with the : 3356  .

• Resting time approximately 30 minutes at room temperature