DEFROSTER DOOR MOTOR -V107-, REMOVING AND INSTALLING, "Low" A/C SYSTEM (AND ON A HEATER WITHOUT A/C SYSTEM): Removing
-- Move the left front seat all the way to the rear.
-- Switch off the ignition.
-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Remove the driver side footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Loosen the left air duct above the central tube and push as far as possible to the outside. Remove the air duct to the left instrument panel vent to do this. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR FRONT .
-- Label the connector -A- and the actuator -C- (to avoid a mix up in case several connectors are disconnected at the same time).
-- Disconnect the connector -A-.
-- Remove the bolts -B-.
-- Remove the actuator -C- from the defroster door shaft -E-.