Heater And A/C Unit, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- Check all seals and grommets on the heater and A/C unit for damage before installing and replace any damaged parts.
-- Coat the grommets -B and C- with grease and install it in the plenum chamber rear panel -A-.
-- Insert the support ring -D- in the grommet.
-- Check the position of the coolant and refrigerant lines in both grommets in the plenum chamber rear panel, and if necessary, align the heater and A/C unit so that the lines are not tensioned in the grommets.
-- On a vehicle with an Auxiliary Heater Heating Element -Z35-, install the connector.
-- Remove the refrigerant line from the front expansion valve.
-- Connect the coolant hoses -A and B- to the heater core coolant pipes (pay attention to the marking) and secure them with a clamp.
-- Evacuate and charge the refrigerant circuit. Refer to Refrigerant Circuit or Working with A/C Service Station (1 Of 2) / Working with A/C Service Station (2 Of 2) .
-- Drain and fill the coolant circuit. Refer to COOLANT, DRAINING AND FILLING .
-- Perform a basic setting on the A/C system. Use the Vehicle Diagnostic Tester in the"Guided Fault Finding" function.
-- Operate the A/C system after charging the refrigerant circuit.