Height Adjustment, Checking

Special tools and workshop equipment required 

• Gauge - Frameless Window: T10391 

If the side window causes wind noise, the height adjustment must be checked.

Procedure 

Courtesy of AUDI OF AMERICA, LLC

-- Determine the measuring point on the side window:

• Dimension -a- = 125 mm, measured from the door window rear edge -1-. Refer to ADJUSTMENT DIMENSIONS - Gap dimension -d- = 125 mm .

-- Position the : T10391  on the upper edge of the side window.

Courtesy of AUDI OF AMERICA, LLC

-- Move the side window -1- to the "closed" position and measure the disk immersion depth to the convertible top -2-.

• Dimension -f-. Refer to ADJUSTMENT DIMENSIONS - Gap dimension -f- = 8.8 mm .

-- Adjust the height adjustment if the side adjustment is not OK. Refer to HEIGHT ADJUSTMENT .