INSTRUMENT CLUSTER WITH Instrument Cluster Control Module -J285-, REMOVING AND INSTALLING, 9S8, 9S9: Removing

-- Move the steering wheel as far to the rear and down as possible. Use the full steering column adjustment range for this.

-- Switch off the ignition and place the ignition key outside of the vehicle.

-- Remove the left and right instrument panel vent. Refer to OVERVIEW - INSTRUMENT PANEL .

-- Remove the bolts -1 and 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Guide both : T40207  between the instrument panel and instrument cluster and attach at the outer vent openings as shown.

-- Using both : T40207  , carefully remove the instrument cluster -2- from the retainer in the direction of -arrow- and tilt toward the rear.

-- Disconnect the connectors:

Courtesy of AUDI OF AMERICA, LLC

1. For the antenna
2. For the fiber-optic cable
3. For the instrument cluster

-- Seal the open wiring harness connector -2- of the fiber-optic cable with the : VAS6223/9  -1-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

TIP:

The protective cap prevents contamination of or mechanical damage to the front surface of the fiber-optic cable which would impair light transmission.

-- Remove the instrument cluster on the front passenger side between the steering wheel and the instrument panel.