Tires, Mounting, Run-Flat Tires And Ultra High Performance Tires

Only trained personnel can perform the assembly work on run-flat tires and ultra high performance tires.
If equipped check the tire pressure monitoring sensor with the vehicle diagnostic tester and if necessary replace.

-- Refer to TIRES, BRINGING TO MOUNTING TEMPERATURE

NOTE:

If equipped handle the glued-on wheel trim carefully. Surface slightly scratched.

Replace the damaged rim wheel trim.

-- Clean the rim.

-- Insert the new tire valve with the :VAS6459 .

-- Coat the rim flanges, tire beads and inside of upper tire beads thoroughly with tire mounting paste.

-- Place the inner side of the tire on the rim.

-- Turn the rim until the tire valve of the tire pressure monitoring sensor aligns with the mounting head.

Fig 1: Identifying Tire Valve / Tire Pressure Sensor On Opposite Side Of Mounting Head

Courtesy of AUDI OF AMERICA, LLC

-- Let the tire dismounting/mounting machine run clockwise until the mounting head is in front of the tire valve or the tire pressure monitoring sensor -arrow-. Slide the lower tire bead over the rim flange.

Fig 2: Locating Tire Valve / Tire Pressure Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Turn the rim until the tire valve of the tire pressure monitoring sensor -1- aligns with the mounting head -2-.

Fig 3: Identifying Tire Valve / Tire Pressure Sensor On Opposite Side Of Mounting Head And Press Holders On Disc Wheel

Courtesy of AUDI OF AMERICA, LLC

-- Install the hold-down device -3- on the rim.

-- Let the tire dismounting/mounting machine run clockwise until the mounting head is in front of the tire valve or the tire pressure monitoring sensor. Slide the upper tire bead over the rim flange.

Fig 4: Identifying Upper Bead Mounting Ending Before Valve/Tire Pressure Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Remove the hold-down device from the wheel rim flange.

CAUTION:

High spring pressure when filling tire.

Risk of injury from tire/rim fragments.

- Wear protective eyewear.

- Set the spring pressure up to the maximum of 3.3 bar.

CAUTION:

There is a risk of damaging the rim due to too high spring pressure.

- Set the spring pressure up to the maximum of 3.3 bar.

-- Inflate the tire to maximum pressure of 3.3 bar (spring pressure).

-- If tire beads do not make contact completely on disc wheel edge, then release air, press off tire bead once more and coat rim flange thoroughly again with tire mounting paste.

-- When the tire bead makes contact on the bead seat, increase the pressure to 4 bar.

-- If the tire bead does not make complete contact with the bead seat, dismount the tire and mount it again. Refer to.

-- Turn the valve insert.

-- Fill the tire with the specified tire pressure.

-- Balance the tire.

NOTE:

Avoid strong braking or acceleration maneuvers during the first 100 to 200 km. Otherwise due to the tire mounting paste the tires can distort on the rim.