Wheel Electronics System (Tire Pressure Monitoring System), BERU

NOTE:

Install the same wheel electronics for all four wheels.

Overview, Beru System

Fig 1: Identifying Tire Pressure Monitor

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.

CAUTION:

Damaged wheel electronics must be replaced.

-- Push the wheel electronics -1- into the bed.

Fig 2: Pressing Wheel Electronics Into Bed

Courtesy of AUDI OF AMERICA, LLC

-- Install on the valve from the back with a microencapsulated screw

NOTE:

Replace the microencapsulated screw.

Tighten the microencapsulated screw to 4 Nm on all models.

Special Tools And Workshop Equipment Required

Torque Wrench 1410:VAG1410 and Torque Wrench 1410 Insert - Accessory Kit:VAG1410/1

Tightening specification for all models: 4 Nm