Decorative Trim, Installing

These light alloy wheels are equipped with replaceable decoration elements. Note the following when installing.

• Make sure the adhesion area on the light alloy wheels and decorative trim are free of dust and grease.
• Clean the adhesion areas with Silicone Remover:LSE 020 100 A3  .

Fig 1: Identifying Adhesive And Adhesive Surfaces

Courtesy of AUDI OF AMERICA, LLC

-- Use the :VAG1628  to apply One-Part Window Adhesive:DH 009 100 A2  on the adhesive surface -arrows-.

• Adhesive point: length = approximately 25 mm and diameter = approximately 10 mm

Fig 2: Identifying Decorative Trim And Lock Washers

Courtesy of AUDI OF AMERICA, LLC

-- Press the decorative trim -2- into the light alloy wheels -1- using firm pressure.

-- Secure the decorative trim -2- to the inside of the light alloy wheel with lock washers -3-.

Minimum curing time: 3 hours at room temperature of minimum 15 °C (59 °F).

-- The light alloy wheel must be balanced again. Refer to WHEEL, BALANCING .