Needle Bearing In Drive Plate, Replacing

Only available with the manual transmission a needle bearing is installed in the drive plate.

Special tools and workshop equipment required 

• Press Piece - 31.5mm: VW418A 
• Press Piece - 28x100mm: VW421 
• Bearing Installer - Multiple Use: 40-103 
• Pneumatic hydraulic press, for example : VAS6654  , not illustrated

Procedure 

Fig 1: Identifying Drive Plate, Removal

Courtesy of AUDI OF AMERICA, LLC

• The transmission is removed. Refer to the appropriate Service Information .
• : 40-103 

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Place the under the drive plate to remove and install.

-- Press out the needle bearing using the : VW421  and workshop press.

• The thinner diameter of the: VW421  points towards the drive plate.

-- Carefully press the needle bearing in all the way using the : VW418A  and workshop press.

Fig 2: Identifying Drive Plate, Removal

Courtesy of AUDI OF AMERICA, LLC

• Installation position: the closed side of the needle bearing faces the engine.

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .