Coolant Recirculation Pump -V50-, REMOVING AND INSTALLING, AUDI A6/A7: Removing
WARNING: This page is about a different variant/trim than selected.
- During installation, all heat shield boots must be installed at the same location.
-- Remove the coolant pipe for the transmission. Refer to TRANSMISSION COOLANT PUMP, REMOVING AND INSTALLING .
-- Remove the heat shield boot.
-- Disconnect the connector -4-.
-- Place a cloth underneath to catch any escaping coolant.
-- Lift the clamps -3 and 5- and remove the coolant hoses.
-- Remove the bolts -2- and remove the Coolant Recirculation Pump -V50- with the bracket.
-- If the pump should be replaced, remove the bolts -1- and remove the bracket.