LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2021 >> A4 Quattro Premium Plus, 2.0L Eng VIN B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Cooling System (4-Cylinder Direct Injection 2.0L 4V TFSI Engine (Ea 888EVO4))) >> 19 Cooling System >> Radiator/Radiator Fan >> Fan Shroud, Removing And Installing >> Fan Shroud, Removing And Installing, AUDI A4/A5 >> Removing

Fan Shroud, Removing And Installing, AUDI A4/A5: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the charge air cooler. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .

GWWA19-12317Courtesy of AUDI OF AMERICA, LLC
CAUTION:

There is a risk of hand injury if the radiator fan turns on by itself.

- Do not reach into the radiator fan when disconnecting the connector.

-- Disconnect the radiator fan connector -arrow-.

-- Unclip the lower air duct -arrow-.

GWWA19-12336Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- and free up the coolant hose on the longitudinal member.

GWWA19-12950Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right bolt -2- and push the radiator bracket -1- with the bolt toward the front in direction of -arrow-.

GWWA19-12308Courtesy of AUDI OF AMERICA, LLC

-- Push the left and right locking latches for the fan shroud at the same time in direction of -arrow- and remove the fan shroud upward from the radiator and remove from underneath.

Fig 1: Fan Shroud
GWWA19-10445Courtesy of AUDI OF AMERICA, LLC