Ignition Coils, Removing And Installing: Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove and disconnect the connector -2- for the Oxygen Sensor 1 Before Catalytic Converter -GX10- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2-, free up the ground wire -1- and remove the double bolt -3- from underneath.

Courtesy of AUDI OF AMERICA, LLC

-- Release the connectors and simultaneously disconnect them from the ignition coils in the direction of -arrow-.

-- Insert the :T10530  in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC

-- Turn the knurled nut -2- clockwise in direction of -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically in direction of -arrow- using the :T10530  .

Fig 2: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC