Overview - Intake Manifold
WARNING: This page is about a different variant/trim than selected.
- Bolt
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- 7 Nm
- Thread cutting
- Throttle Valve Control Module -GX3-
- With
- Throttle Valve Control Module -J338-
- EPC Throttle Drive -G186-
- EPC Throttle Drive Angle Sensor 1 -G187-
- EPC Throttle Drive Angle Sensor 2 -G188-
- Removing and Installing. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING .
- Cleaning. Refer to Throttle Valve Control Module -GX3-, CLEANING .
- With
- Seal
- Replace after removing
- Intake Manifold Runner Position Sensor -G336-
- O-Ring
- Replace if damaged or leaking
- Intake Manifold
- Removing and Installing. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Ball Pin
- 9 Nm
- For the engine cover
- O-Ring
- Replace if damaged or leaking
- Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-
- Removing and Installing. Refer to Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- Ball Pin
- 9 Nm
- For the engine cover
- Intake Manifold Runner Control Valve -N316-
- Removing and Installing. Refer to Intake Manifold Runner Control Valve -N316-, REMOVING AND INSTALLING .
- Vacuum Hose
- Vacuum Hose
- From the vacuum pump
- Vacuum Hose
- Bracket
- For the connectors
- Bolt
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- 5 Nm
- Thread cutting
Intake Manifold - Tightening Specification and Sequence
-- Tighten the bolts -1 to 10- to 8 Nm in the sequence shown.