Vibration Damper, Removing And Installing, Version 1: Installing

Install in the reverse order of removal while noting the following:

• Replace the bolt with the O-ring after removing.

-- If necessary, remove the : T10531/4  -B- and : T10531/3  -A- from the : T10531/6  .

-- Attach the vibration damper. At the same time, pay attention to the tooth contour of the chain sprocket -arrow-.

-- Place the : T10531/3  -A- on the : T10531/6  .

• At the same time the hex fitting points to the vibration damper.

-- Install the : T10531/4  -B-. While doing so, move the vibration damper back and forth slightly to check if the vibration damper is seated correctly in the tooth contour.

-- Tighten the knurled nut until the vibration damper can no longer be turned.

-- Place the : T10531/1  as shown on the vibration damper and tighten the knurled bolt -1 and 3- in the adapter hand-tight.

Courtesy of AUDI OF AMERICA, LLC

-- If necessary, align the adapter on the inner hex socket -2- with a 4 mm hex socket wrench and counterhold.

• The arrow marking on the : T10531/1  must point upward.

-- Remove the : T10531/4  -A- and loosen the tensioning pin -B-.

-- Unscrew the : T10531/6  and remove it with the : T10531/3  .

-- Install a new vibration damper bolt hand-tight with an oiled O-ring -1-.

-- Remove the knurled bolts -1 and 3- and remove the : T10531/1  .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the : T10531/5  .

-- Tighten the vibration damper bolt, to do so, use the : T40378  -1-.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

• Replace the timing chain cover bolts after removing.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .