AUDI A4 Type 8W, From My 2018: Notes
NOTE:
Inner diameter 66.5 mm, hole circle 112 mm, 5 wheel bolts, tightening specification 120 Nm
Applies to sedan and avant
Audi S4:
Audi RS-4:
------------------------------------------------------------------------------------------------------------------------
NOTE:
In addition to the registered tire package in the Certificate of Conformity, a conversion to different wheel/tire combinations is technically possible.
These technical possibilities are found in the Wheel and Tire Guide.
The following conditions must be fulfilled to convert to a different tire/wheel combination:
- The operating license of the vehicle will expire in the German Federal Republic if a wheel/tire combination is applied that is not in the registration document or in the Certificate of Conformity. To extend the operating license, the vehicle must be inspected according to 19.2 / 21 StVZO by an officially recognized expert or inspector of motor traffic. Then the issue of a new operating license is requested at the appropriate licensing authority (registration service).
- A valid general operating approval or report from the German Federal Motor Vehicle Registration Agency for the different tire/wheel combination "may" replace the vehicle inspection.
- Follow the rules and regulations of the corresponding country.
- The corresponding country-specific registration regulations are to be followed.