Glass Panel, Adjusting, A4 AVANT And Market-Specific Version: Notes
Adjustment Dimensions
- Front Glass Panel
- Dimension -a- = 1.9 ± 1.1 mm
- Dimension -b- = 1.2 ± 0.5 mm
- Dimension -c- = 1.0 ± 0.5 mm
- Dimension -f- = 10 ± 1.2 mm
- Rear Glass Panel
- Dimension -d- = 0.3 + 0.7- 0.3 mm
- Dimension -e- = 21.9 ± 1.2 mm
- Roof
Height Adjustment
- Only adjust the front glass panel at the front edge and the rear glass panel at the rear edge.
- To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.
-- Check the adjustment of the front -1- and rear -2- glass panels with a depth gauge, for example.
- Dimension -a- = 1.9 ± 1.1 mm
- Dimension -b- = 1.0 ± 0.5 mm
- Dimension -c- = 0.3 + 0.7- 0.3 mm
-- Remove the left and right inner seal on the side.
-- To adjust the front glass panel -1-, reach through the openings in the side rubber trim on the glass panel to loosen both of the front screws -left arrows-.
-- Adjust the glass panel and tighten the screws.
-- To adjust the rear glass panel -1-, loosen the screws -arrows-.
-- Adjust the glass panel and tighten the screws.
-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .