Outer Sunroof Seals, Removing and Installing:: Installing

• The vehicle and the seal must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.
• Do not stretch the seal when installing it.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution :D 009 401 04  and let dry.

-- Apply Bonding Agent :D 355 205 A2  -1- on the painted side of the adhesive surface -2- using the Applicator :D 009 500 25  -3- and let it dry for ten minutes.

Fig 1: Applying Bonding Agent To Adhesive Surface On Paint Side Using Applicator

Courtesy of AUDI OF AMERICA, LLC

• If the Bonding Agent :D 355 205 A2  dries longer than two hours, then it must be primed again.

-- Remove the protective film from adhesive tape.

-- Position the seal on the sunroof frame and on the glass panel and push on along the entire length.

• Resting time approximately 30 minutes at room temperature