Overview - Input Shaft 1

Fig 1: Input Shaft 1 Exploded View

Courtesy of AUDI OF AMERICA, LLC

Small Needle Bearing
- Bearing "12"
- To the input shaft mounting 2 on the input shaft 1
Large Needle Bearing
- Bearing "D"
- To the input shaft mounting 2 on the input shaft 1
Sensor Wheel
- Replace after removing
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Input Shaft 1
- With splines for the 1st and 3rd gear
- Can be removed and installed individually without disassembling the entire gear set. Refer to INPUT SHAFT 1, REMOVING AND INSTALLING INDIVIDUALLY .
- Disassembling and Assembling. Refer to INPUT SHAFT 1, DISASSEMBLING AND ASSEMBLING .
Thrust Washer
- For the 5th gear assembly
Needle Bearing
- For the 5th gear assembly
5th Gear Assembly
Synchronizer Ring
- For the 5th gear assembly
- Do not interchange with the synchronizer ring for 7th gear
Synchronizer Hub
- Removing. Refer to Figure.
- Installing. Refer to Assembling .
Thrust Pieces
- Quantity: 3
Locking Collar
Synchronizer Ring
- For the 7th gear
- Do not interchange with the synchronizer ring for 5th gear
7th Gear Wheel
Needle Bearing
- For the 7th gear
Inner Race/Needle Bearing
- For the 7th gear
- Removing. Refer to Figure.
- Installing. Refer to Assembling .
Thrust Washer
- For the 7th gear