2021 A4 / S4 / A4 ALLROAD®

Audi Pre-Delivery Inspection


_{Stock Number}	_{Dealer Number}	_{R.O. Number}

_VIN	_{Road Test Mileage Out}	_{Road Test Mileage In}

Reminders

→ All items must be completed prior to customer delivery by a certified Audi technician

→ Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection

→ Guided Fault Finding must be used, session must be completed and sent to GFF Paperless

→ Total PDI Test must be completed prior to any other work involving the scan tool (special function tab -> Total PDI Test)

→ Start Guided Fault Finding with the engine running to ensure control modules in transport mode are identified

→ For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information

→ For items marked with **, follow instructions for stock inventory vehicle

√ all completed items
Vehicle Preparation
□	Check Elsa for open campaigns and updates
□	Verify Audi Phone Box Customer Registration form is present in car and fill out "Serial Number" field. Check Elsa "Vehicle Information" Section or location sticker on car. See TSB 2051720
□	Perform any open campaigns*
□	Perform diagnostic work*
□	Perform TSB 2058096/1 "91 Audi connect has no function, SOS LED is off, and SOS warning message in FPK"
□	- Perform MMI Menu Reset: 5F-Information Electronics >> Guided Functions >> Basic Settings >> Reset MMI Menu Settings
□	- Deactivate privacy mode: Main Menu >> Privacy >> Activate Privacy Settings (Turn off)
□	- Turn Vehicle Off and allow Bus Sleep Cycle
□	Install front license plate carrier (if necessary)*
Exterior
□	Check all key buttons and features*
□	Inspect exterior for damage, dings, dents and surface scratches. Report and repair any damage before delivery to the customer
Lighting and Windshield
□	Test exterior lighting functions
□	Test windshield washers. Correct aim if necessary*
Trunk Inspection
□	Verify trunk is operational
□	Verify operation of emergency release handle
□	Install wheel bolt cover removal tool from PDI kit into trunk tool kit*
□	Verify tool kit is installed securely in luggage compartment
□	Set spare tire pressure*
□	Check battery clamps for proper torque*
Interior
□	Verify operation of all seat belts and latches
□	Check operation of window, lock, and seat controls*
□	Inspect mirrors for proper operation*
□	Check rear view mirror operation*
□	Verify operation of all interior lights
□	Verify operation of heated seats
□	Verify operation of rear heated seats (if equipped)
□	Verify operation of ventilated seats (if equipped)
□	Verify proper operation of climate control*
□	Inspect operation of all power outlets*
□	Check panoramic sunroof and sunshade operation*
□	Verify the glove compartment opens and closes properly
□	Verify operation of front Passenger Occupant Detection System
Settings
□	Set Time source setting to "GPS" and set Auto daylight savings time to "on" *
□	Verify operation of MMI® touch
□	Set Time to "Automatic setting" and "Automatic time zone"
□	Verify and set language and measurement units*
□	Verify Speech Dialog System is operating
□	Set "Entertain. Fad." in parking aid to an audible level*
□	Set "Music volume while parking" to medium*
□	Set dealership location in navigation (if equipped)*
□	Turn off Manual Speed Warning* (if equipped)*
Media / Radio / SAT
□	Verify operation of aux. input
□	Insert SD card and test function of slots
□	Verify HD Radio_TM is turned "off"*
Audi connect® (USA ONLY) (if equipped)
□	Turn on the Wi-Fi® hotspot (if equipped)*
□	Check Wi-Fi® hotspot visibility. No data available at PDI (if equipped)*
□	Enable satellite map view for navigation (if equipped)*
On-Hoist Inspection
□	Remove transport suspension blocks (follow ELSA instruction)
□	Check steering, boots, brake system, hoses, tires and wheels for damage
□	Check underside of vehicle for fluid leaks and loose components
□	Inspect wheel bolts for proper torque*
□	Install wheel locks (if equipped)
□	Install wheel bolt covers and center caps as supplied*
□	Set and store tire pressures for either sold vehicle OR stock inventory vehicle*
Driving Performance
□	Check horn operation
□	Verify hold and release of electronic parking brake
□	Verify engine Start-Stop System functionality*
□	Verify engine performance and acceleration*
□	Verify transmission operation, including shift paddles
□	Test drive vehicle applying brakes several times*
□	Check steering / tire alignment
□	Check for squeaks, rattles and wind noise. Repair any squeaks, rattles or wind noises before delivery to the customer
□	Calibrate rear view mirror*
□	Verify quality of radio reception in AM / FM / SiriusXM® bands
Driver Assistance
□	Verify cruise control / ACC functionality (if equipped)
□	Verify Audi side assist functionality (if equipped)
□	Verify operation of Audi parking system (if equipped)*
□	Verify all vehicle Head-up display functionality (if equipped)*
□	Activate NAV and follow directions back to dealership (if equipped)
Post-Road Test Inspection
□	Verify SOS button is green and Roadside assistance button LED will remain off
□	- It may take up to 20 minutes for the emergency call system to activate (LED turns green) after flight/transport mode deactivation
□	- The vehicle must not be delivered to the customer if the emergency call function has not been successfully activated (LED lights up in green)
□	Interrogate fault memory and upload diagnostic log to GFF Paperless Server
□	Check service interval and verify correct interval is displayed
□	Check engine oil level*
□	Check all fluid levels and top off if necessary
□	Ensure the yellow tire pressure tag is installed on the steering wheel
□	Apply 30 Day Inventory Maintenance Sticker**
□	Install showroom charger to ensure battery remains charged at all times**

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and Quality Standards, and has met the standards for Perfect Delivery.


_{Technician Signature}	_{Last 8 of VIN}	_{Completion Date}