Coolant Shut-Off Valve -N82-, Removing And Installing: Installing

Install in reverse order of removal. Note the following.

TIP

• Since only a small amount of coolant flowed out of the coolant circuit when removing the Coolant Shut-Off Valve -N82- as described above, the coolant flows into Coolant Shut-Off Valve -N82- after installing and removing the hose clamps (additionally opening the coolant expansion tank cap).
• The shut-off valve -A- is secured to the noise insulation via the rubber bushing -L- (with bearing bushings and washers) the nuts -G- and the bolts -F- on the bracket -K-.

-- Check the rubber bushing -L- is seated correctly in the bracket -K-.

-- Villa and bleed the coolant circuit. Refer to COOLANT CIRCUIT, BLEEDING .

Tightening Specification