Evaporator Vent Temperature Sensor -G263-, Removing And Installing: Removing

Fig 1: Locating Tabs For Dust & Pollen Filter

Courtesy of AUDI OF AMERICA, LLC

-- Position the front passenger seat as far back as possible.

-- Switch off the ignition.

-- Remove the screw clips -A-.

-- Loosen the insulation -B- from the heater and A/C unit air intake manifold and remove.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- If equipped, remove the air duct to the glove compartment cooling. Refer to AIR DUCT FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .

-- Remove the right footwell vent (front passenger side). Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Loosen the Evaporator Vent Temperature Sensor -G263- -A- (with the connector -B- connected) from the evaporator housing on the heater and A/C unit -arrow- and remove.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the locking mechanism -C- and remove the connector -B-.