Particulate Filter Differential Pressure Sensor - G1037-, REMOVING AND INSTALLING: Removing

• During installation, all heat shield boots must be installed at the same location.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Open the heat shield boot.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the bolt -1- and loosen the hose clamps -3-.

-- Remove the Particulate Filter Differential Pressure Sensor -G1037-.

-- Spray the hoses on the Particulate Filter Differential Pressure Sensor -G1037- with soapy water.

-- To prevent the connection from breaking, carefully and evenly pull the hoses off of the connection.