Fuel Tank Pressure Sensor -G400-, Removing And Installing: Removing

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Disconnect the vent and bleeder lines -1, 2 and 3-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .

Fig 1: Bleeder Line

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the vent and bleeder lines from the bracket -arrow- and move to the side.

-- Disconnect the connector -4- by unlocking the connector safety catch.

-- Remove the bolts -1-.

Fig 2: Fuel Tank Pressure Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuel tank pressure sensor -2- from the EVAP canister in direction of -arrow-.