Round Connector Systems

NOTE:

If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to SECONDARY LOCK .

-- Guide the release tool which fits the connector housing into release channel on connector housing.

Fig 1: Identifying Terminal At Wire Pushed Into Terminal Housing

Courtesy of AUDI OF AMERICA, LLC

-- Grasp contact at wire and push it gently into connector housing in direction of -arrow-.

NOTE:

By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and released using the release tool.

-- At the same time, push the release tool in the direction of the connector housing -arrow- and pull the released contact out of the connector housing.

-- After removing the contact, release tool can be pulled out of the connector housing again.

Fig 2: Identifying Released Terminal Pulled Out From Terminal Housing

Courtesy of AUDI OF AMERICA, LLC