LEFT SEAL, REPLACING, 0D3 "quattro sport" AND 0BX "quattro sport": Installing

Install in reverse order of removal. Note the following:

Install the right shaft seal.

Fig 1: Identifying Flange Shaft Seal, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

-- Install the shaft seal all the way. Be careful not to bend it.

Installing the left shaft seal 

Fig 2: Identifying T40221

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

-- Install the shaft seal all the way. Be careful not to bend it.

-- Insert the flange shaft.

Tip:

• If it is not possible to install the flange shaft all the way in by hand, then use a plastic mallet.

-- Tighten the new flange shaft bolt to the tightening specification -item  : Bolt.

-- Install the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .

-- Check the ATF level in the rear final drive. Refer to ATF LEVEL, CHECKING .