Rear Brake Pad Wear Indicator Sensor, Removing And Installing: Installing
NOTE:
Check the brake pad wear indicator sensor contact for damage and replace if necessary.
Make sure that the brake pad wear indicator sensor contact fits correctly in the brake pad.
If the clips go missing, the brake pad wear indicator sensor wire must be replaced.
-- Insert the contact -4- for the brake pad wear indicator sensor with the clip -3- until it engages in the inner brake pad.
-- Secure the brake pad wear indicator sensor wire with the dust protective cap -2- and the clip -1-, as shown.
-- Bring the connector -1- into its installation position and turn in the direction of -arrow- until the tab -3- engages in the hole -4- on the bracket.
-- Connect the connector -2-.