Brake Caliper, Removing And Installing, Steel Brakes 1LA/1LB: Removing

-- Remove the front wheel. Refer to WHEEL, CHANGING .

-- Disconnect the connector -2-.

Fig 1: Brake Pad Wear Sensor -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release the tab in direction of -arrow A- and turn 90° in direction of -arrow B- at the same time. Then remove and free up the brake pad wear sensor -1- from the bracket.

TIP:

Courtesy of AUDI OF AMERICA, LLC

Pushing the brake pad -2- slightly into the brake caliper using suitable pliers -1- makes it easier to remove the brake caliper from the brake rotor. To prevent damage to the paint coat on the brake caliper, place a piece of rubber -3- between the pliers and the brake caliper. (Shown on a different brake caliper)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Carefully remove the brake caliper -1- with the brake carrier and installed brake pads from the brake rotor; pay attention to the brake hose while doing so.

-- Hang the brake caliper using a suitable wire.