Brake Caliper, Removing And Installing, Steel Brakes 1LC/1LD/1LE/1LF/1LG/1LH: Removing

-- Remove the front wheel. Refer to WHEEL, CHANGING .

-- Disconnect the connector -2- and free up the wiring harness at the bracket.

Fig 1: Brake Pad Wear Sensor -1-

Courtesy of AUDI OF AMERICA, LLC

-- If the brake pads or the brake pad wear sensor -1- should be removed, release the tab in direction of -arrow A- and turn it 90° in direction of -arrow B- at the same time. Remove the brake pad wear sensor from the bracket and free it up at the protective cap.

TIP:

Courtesy of AUDI OF AMERICA, LLC

Pushing the brake pad -2- slightly into the brake caliper using suitable pliers -1- makes it easier to remove the brake caliper from the brake rotor. To prevent damage to the paint coat on the brake caliper, place a piece of rubber -3- between the pliers and the brake caliper. (Shown on a different brake caliper)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -4 and arrows-.

-- Carefully remove the brake caliper -1- with the bracket -3- and installed brake pads from the brake rotor; pay attention to the brake hose while doing so.

-- Hang the brake caliper using a suitable wire.