Overview - Luggage Compartment Roll Cover

Fig 1: Exploded View Of Luggage Compartment Roll Cover

Courtesy of AUDI OF AMERICA, LLC

Luggage Compartment Cover Motor 1 -V473-
- Equipped on some models
- Component location
  - All except g-tron: behind the lock carrier trim panel
  - g-tron: behind the left luggage compartment side trim panel
- Only available with -6-
- Removing and installing. Refer to LUGGAGE COMPARTMENT COVER MOTOR, REMOVING AND INSTALLING .
Rivet
Locking Pin
- Not available separately from the repair kit. Refer to the Parts Information.
- Riveted with roll cover
Roll Cover Catch
- Clipped into the guide rails
- Removing and installing. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
Clip
- Replace damaged or deformed clips
- Remove any remaining clips in the D-pillar mounting points using the Omega Clip Tool :T40280 . To install, insert into the roll cover guide rail.
- Insert into the roll cover guide rail
Roll Cover Guide Rail
- Only available together with -1-
- Removing and installing. Refer to LUGGAGE COMPARTMENT COVER MOTOR, REMOVING AND INSTALLING .
Bolt
- 4.5 Nm
Bolt
- 2.5 Nm
Luggage Compartment Roll Cover
Frame
- For luggage compartment roll cover handle
- Not available separately from the repair kit. Refer to the Parts Information.
- Replacing. Refer to LUGGAGE COMPARTMENT ROLL COVER HANDLE, REMOVING AND INSTALLING .
Handle
- For luggage compartment roll cover
- Not available separately from the repair kit. Refer to the Parts Information.
- Replacing. Refer to LUGGAGE COMPARTMENT ROLL COVER HANDLE, REMOVING AND INSTALLING .
Bolt
- 0.35 Nm
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- Thread cutting
- Quantity: 2
Release Cable Bracket
Release Cable Adjuster
Nut
- 2.5 Nm
- Quantity: 3