General Information - Name Badges And Emblems, Replacing

Special tools and workshop equipment required 

• Roller: 3356 
• Cleaning Solution: D 009 401 04 

• Loosened name badges and emblems must be replaced.
• The vehicle as well as the name badges and emblems must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04  and let dry.

-- Warm the adhesive areas to approximately 40 °C (104 F) using a hot air blower.

• Neighboring components must be protected against temperature effects.

-- After successfully assembling, press on the emblems again with the roller.

• Resting time approximately 30 minutes at room temperature