Hood Heat Shield, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- The vehicle and the heat shield must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Remove the protective film -1- from the adhesive tape.
-- Push the tabs -4- in the specified cut-out on the insulation -3- -arrows-.
-- Position the heat shield -2- on the body contour and press on.
- Resting time approximately 30 minutes at room temperature
Installing
Install in reverse order of removal.