Undamaged Window Glass, Preparing For Installation

• The vehicle and the window glass must be at room temperature.
• The adhesive bead must be free of dirt and grease.
• Cut the adhesive bead back/evenly just before installing, but do not completely remove.
• Glass/paint primer is electrically conductive and therefore must not touch the bus bar on the rear window defogger, for example.
• The window glass must be inserted within 15 minutes of applying the sealant.

-- Cut the rest of the adhesive on the flange using the : VAG1561A  and : VAG1561/8  or using a Scraper from the Scraper Set: VAS861005  so that it is even just before installing, but do not remove it completely.

TIP:

The residue acts as a base for the adhesive to be applied.

• If bonding is not performed immediately after the cutting back the adhesive on the flange, the remaining material must be activated with the : D 181 802 M1  . Drying time: 10 minutes

-- Apply the adhesive. Refer to Adhesive Application: .