Height Adjustment, Checking

Special tools and workshop equipment required 

• Adhesive Tape

If the door window causes wind noise, the height adjustment must be checked.

• Adjustment dimensions. Refer to FRONT DOOR WINDOW, ADJUSTING .

Procedure 

-- Determine the measuring point on the door window:

• Dimension -a- = 294.5 mm measured from the center of the inner door seal -1-. Refer to ADJUSTMENT DIMENSIONS - Dimension -e- = 294.5 mm measured from the center of the inner door seal .

  Courtesy of AUDI OF AMERICA, LLC

-- Apply the adhesive tape to the measured point -2-.

Courtesy of AUDI OF AMERICA, LLC

-- On the adhesive tape, mark reference line -1- from the door window upper edge.

• Dimension -d-. Refer to ADJUSTMENT DIMENSIONS - Gap dimension -d- = 3.0 mm .

-- Close the door.

• The reference line -1- on the adhesive tape must align with the inner door seal lower edge -2-.

  Courtesy of AUDI OF AMERICA, LLC

TIP:

The measurement of the window depth can be performed using the : T10391  at the measuring points.

-- Adjust the door window again if the first height adjustment is not OK. Refer to HEIGHT ADJUSTMENT .