Driver And Front Passenger Backrest Adjustment Motor -V45- / -V46-, Removing And Installing: Removing
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the : VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the tunnel-side seat side trim. Refer to SEAT SIDE TRIM ON TUNNEL SIDE, REMOVING AND INSTALLING .
-- Remove the seat side trim on the side sill side. Refer to SEAT SIDE TRIM ON SIDE SILL SIDE, REMOVING AND INSTALLING .
Standard/Sport Seat:
-- Remove the backrest cover. Refer to BACKREST COVER, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
-- Disengage the hooks on the backrest frame -arrows-.
-- Disengage the hooks from the cover -A arrows-.
-- Disengage the molding from the bottom of the backrest frame -arrow B-.
-- Disengage the hooks for the side bolsters on the backrest frame -arrows-.
Super Sport Seat:
-- Remove the backrest cover and side trim. Refer to BACKREST COVER, REMOVING AND INSTALLING, SUPER-SPORT SEAT .
-- Remove the clips -arrows- on the backrest frame with the : 80-200 .
-- Detach the lower molding -1- from the backrest frame.
-- Disengage the molding -2- on the bracket on the backrest frame.
-- Disengage the tab -1- from the cushion and cover (tunnel-side) from the hooks for the side bolster -2-.
-- Disengage the cover (tunnel-side) hooks -3- on the backrest frame.
Continuation for all Seat Versions:
-- Loosen the cover -1- with cushion -2- from the backrest frame and remove carefully under the backrest forward in direction of -arrows-.
-- Mark the left and right angle position of the backrest hinge to the backrest frame with paint -arrows-.
-- Destroy the lock washer -1- and remove it.
-- Push the adjustment shaft -2- to the opposite side out of the backrest frame.
-- Remove the bolt -arrow- and remove the backrest adjustment motor -2-.
-- Disconnect the connector -1- from the removed backrest adjustment motor.