Calibration System: VAS721001, INSTALLING AND ALIGNING: Notes

Special tools and workshop equipment required

After performing service work on the vehicle, it may be necessary to recalibrate the peripheral camera system. Specifically, this is the case after:

Replacing one or more cameras
Peripheral Camera Control Module -J928- replacement
Software flash from the Peripheral Camera Control Module -J928-
Record the data set on the Peripheral Camera Control Module -J928-
Repair work on components in which a camera is installed or that influence the component location of the camera
Wheel Alignments
When adjusting the overlap range of the individual cameras
The standing height of one axle changes by more than 5 mm
The standing height of the entire vehicle changes by more than 10 mm