Rear Axle Camber, Adjusting

Special tools and workshop equipment required

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.

Mandatory Replacement Parts

Procedure

-- Remove the nut -1- from the subframe/rear lower transverse link threaded connection and install the new nut all the way.

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the camber by rotating the adjusting bolt -2-.

NOTE:

To turn the adjusting bolt, turn the hex head at the >>top of the bolt<<.

NOTE:

The maximum adjustment range is 135° to left or right of center position.

Do not rotate the adjusting bolt -2- further once the end position has been reached or the components will be damaged.

For clarity the rear wheel is not shown.

-- Tighten the nut and check the camber value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES, SEDAN / AVANT .

Tightening Specifications